Brother 884-639 Sewing Machine User Manual


 
7
Before You Begin (1)
Power Cord
Foot Controller
Power Switch
I
O
Hand Wheel
1
2
3
4
5
6
7
Stitch Length Regulator
Reference Mark
Lower number
= shorter stitches
Higher number
= longer stitches
Stitch Length
Reverse Stitch
Lever
Upper Thread Tension
Loosen Tighten
Tension Block
Thread Tension Dial
When tighter thread tension is
desired, turn the tension dial
to the right. Upper and bobbin
threads will meet on right side of
the fabric.
When looser thread tension is
desired, turn tension dial to the
left. Upper and lower threads
will then meet on wrong side of
fabric.
Power Switch
Flip power switch to “I” position
to turn on.
To switch power off, flip switch to
“O” position.
Hand Wheel
Position needle using hand
wheel.
Always turn hand wheel towards
you.
CAUTION
Be sure to keep the area under
and around the needle clear.
Stitch Length Regulator
Adjust desired stitch length
using stitch regulator dial.
Reverse Stitch Lever
Sewing in reverse is possible
when the reverse stitch lever is
in the lowered position.
Make sure to continuously press
the lever to its lowest position
when reverse sewing is desired.
When the feed adjustment dial is
set between 5-7 mm, the reverse
stitch length is always 5 mm.
Power Cord and Foot Controller
WARNING
Please use common household
current.
Plug in cord.
Plug foot controller into machine.
When you press the foot controller
down lightly, the machine will run
at a low speed. When you press
harder, the machine’s speed will
increase. When you take your foot
off the foot controller, the machine
will stop.
Slower
Faster