Brother 484C Sewing Machine User Manual


 
8. ELECTRIC MECHANISM
--. Operation panel DIP switches (KE-436B, 436C)
Note:
Always turn off the power before setting the DIP switches.
KE-430B, 430C series
148
1086Q
A
ll DIP switches are set to OFF at the time o
f
shipment.
DIP switch A
Switch Motion when set to ON
DIPA-1
Work clamp does not automatically lift after
sewing is completed.
DIPA-2 Pedal mode is switched.
See “8-8. Setting the work
clamp mode”
DIPA-3 -
DIPA-4 -
DIPA-5
After sewing is completed, work clamp does not automatically rise. (only in split
mode)
DIPA-6 Clamping force output is produced. (Inner clamping device available as an option)
DIPA-7 -
DIPA-8 Thread breakage detector device is activated (available as an option).
DIP switch B
Switch Motion when set to ON
DIPB-1 Single split mode activated
DIPB-2 -
DIPB-3 Thread is not trimmed after an emergency stop.
DIPB-4 Needle cooler output is produced. (Needle cooler available as an option)
DIPB-5
When a rotating-type thread breakage detector device is used, detection precision
is increased from 8 to 14.
When a fiber-type thread breakage detector device is used, detection precision is
increased from 5 to 10.
DIPB-6
Fiber-type thread breakage detector device is ON, and DIP switch A-8 is ON
(available as an option).
DIPB-7 -
DIPB-8 -