Filter
Top Products
4. Snap the assembled exterior hood on its backplate and secure with 2 provided screws
(no. 8 x 3/4” long).
3. Using 4 no. 8 x 1½” screws, mount the the exterior backplate to the exterior wall. Seal the
outline with caulking.
3.8 INSTALLING THE TANDEM TRANSITION KIT (CONT’D)
3.8.4 C
ONNECTING TANDEM TRANSITION TO THE DUAL EXTERIOR HOOD (CONT’D)
2. Join the end of the Tandem Transition to the rear of the exterior backplate. Secure with
2 Xmas tree pins and seal properly with duct tape.
3. INSTALLATION (CONT’D)
VD0085
CAUTION
The exterior backplate must be installed with the word “TOP” pointing upward.
XMAS TREE PIN
VD0086
VD0087
SCREW
- 15 -