Filter
Top Products
9
6. Line the mounting bracket up over the
plastic screw anchors.
7. Screw the
mounting bracket
to the ceiling or
wall through the
mounting slots
using the two
screws provided.
8. Before attaching
the alarm to the
bracket, insert
the 9V battery
(included) into
the battery
compartment.
Match the
terminals on the
end of the
battery with the
terminals on the
unit. Match “+”
to “+” and “-” to “-.” Push the battery in until
it snaps in securely and cannot be shaken
loose. If the battery is not snapped in
completely, the unit cannot receive battery
power.
N
OTE:
The unit may beep briefly when you install the
battery. This is normal.
WARNING!
The battery door will not close unless a
battery is installed. This warns you the unit
will not operate without a battery.
9. Align the tabs on the base with the tabs on
the mounting bracket. Turn the base until it
snaps into place.
10.If the cover does not line up the way you
wanted, adjust it by slowly rotating it in
either direction.
11.Test the smoke/CO alarm. See “Weekly
Testing” (page 14) for details.