Filter
Top Products
ASSEMBLY
10
3. Slide hose clamp over end of hose. Slide suction hose
onto hose barb (Figure 4).Tighten hose clamp securely
using a standard 1/4” (6mm) screwdriver.
Attach Suction Hose to Strainer Basket
Slide hose clamp over hose.Attach open end of suction
hose to strainer hose barb (Figure 5).Tighten hose clamp
securely using a standard 1/4” (6mm) screwdriver.
Connect Discharge Hose (Optional)
If desired, use a commercially available hose. DO NOT use
a hose with an inside diameter smaller than the pump’s
discharge port size.
1. Slide barb cuff over hose barb. Insert rubber seal into
end of barb cuff (see Figure 2, earlier).
2. Screw hose barb assembly onto pump in clockwise
rotation until hose barb assembly is tightened securely
(Figure 6).
3. Slide hose clamp over end of discharge hose. Slide
discharge hose onto hose barb (Figure 7).Tighten hose
clamp securely using a standard 1/4” (6mm)
screwdriver.
Figure 5 - Attach Suction Hose to Strainer Hose Barb
Figure 6 - Connect Hose Barb to Pump
Figure 7 - Connect Discharge Hose to Hose Barb
Figure 4 - Connect Suction Hose to Hose Barb