Filter
Top Products
Step 6
Reinstall the E-Units (set aside from being removed from the rear) as follows:
1. Rotate the E-Unit 180 degrees (from original position).
2. Cross over to opposite corner of cart.
3. Tilt in and set against offset of bottom panel (of cart).
4. Grip the top and tilt to the upright position.
When repositioned correctly, the E-Unit outlets face the interior and power switch should face the front.
Reinstall the E-Unit bracket assemblies (make sure that the top flange of the E-unit is aligned with the slot in the
bracket assembly) and tighten screws securely.
Plug in the E-Units power cords into the bottom outlets of the timer assembly.
(Note that the 'A', 'B' designation of the cords are now opposite the timer 'A, 'B' designation set at the factory.
This will not affect the operation of your cart.)
Press each E-Unit power cord into the two wire clips located on the side panel, bottom.
Do not use the rear, bottom wire clip.
clip
Installation is now complete and ready for use.
offset