Filter
Top Products
10-Gallon Tank with Eye Wash and Optional Heater Jacket
Installation Instructions S19-690LHS, S19-690H
Bradley Corporation • 215-084 Rev. L; EN 02-586 3
Installation Instructions
Step 1: Install eye wash
1. Attach the eye wash to the tank
outlet with pipe sealant (supplied
by installer) (see Figure 1).
IMPORTANT: When attaching the
eye wash to the tank outlet, hold
the adapter (Item 3) with a
wrench to prevent stripping.
Failure to do so may damage
the seal and cause leakage.
2. Attach the pressure gauge to the
adapter on the pressure side of the
tank with pipe sealant (supplied
by installer) as shown in Figure
2 on page 6.
3. FOR OPTIONAL HEATER
JACKET:
• Secure the pipe insulation and
yellow jacket to the eye wash
assembly.
• Wrap the heater belt around
the tank at a height of four
inches from the bottom of the
tank and fasten securely.
• Connect the heat trace cable to
the junction box.
• Slide the jacket up the side of
the tank and pull the draw-
string at the top of the jacket.
• Place the junction box in the
pocket on the inside of the
jacket.
Figure 1
Back View