Filter
Top Products
10-Gallon Tank with Eye Wash and Optional Heater Jacket
S19-690LHS, S19-690H Installation Instructions
Bradley Corporation • 215-084 Rev. L; EN 02-586
2
Bradley 10 Gallon Tank Warranty
Bradley Corporation warrants to commercial and institutional purchasers only each fixture free from defects
in material and workmanship under normal use and service upon the following terms and conditions:
1. We will replace, without charge, any part which proves to be defective within one year from the date
of our invoice at our option, F.O.B. Menomonee Falls, Wisconsin.
2. This warranty does not cover installation or any other labor charge and does not apply to fixtures
which have been damaged by accident, abuse or improper maintenance.
3. The repair or replacement of the defective fixtures as stated in this warranty shall constitute the sole
remedy of the purchaser, and the sole liability of the Bradley Corporation under this warranty.
Bradley Corporation shall not otherwise be liable under any circumstances for incidental, consequential
or indirect charges caused by defects in fixtures or any delay in the repair or replacement thereof.
4. This warranty extends only to commercial and institutional purchases and does not extend to any
others, including consumer, customers of commercial and institutional purchasers.
5. This warranty is in lieu of all other warranties expressed or implied, including any implied warranty
of merchants ability or fitness for a particular purpose, or otherwise.
6. Bradley emergency fixtures are to be used as a supplement to first aid treatment. Bradley
Corporation cannot guarantee that when used this emergency equipment will prevent serious injury
or the aggravation of existing or prior injuries. No other warranties, expressed or implied are authorized,
provided or guaranteed by Bradley Corporation.
Pre-Installation Information
Operation
The Bradley 10-Gallon Tank provides emergency protection in areas where permanent water supply
is not available. After emergency use of the portable unit, further cleansing of the injury should be
administered at a conventional plumbed fixture.
Components
10-Gallon Tank: The stainless steel tank has built-in carrying handles. The tank has a tire filler
valve with 0-160 PSI air gauge. Pressure relief valve prevents accidental over-pressurization.
(NOTE: Do not exceed 130 PSI tank pressure.) Empty tank weighs 23 lbs., 86 lbs. full.
Eye Wash: The twin chrome-plated, soft flow eye wash heads have automatic flow control and stay-
open valve. Flow maintained approximately 15 minutes from eye wash.
Optional Heater Jacket: The insulated heater jacket is made of yellow 200-Denier foam-backed
nylon and has a clear vinyl pocket to house the junction box. The eye wash yoke is wrapped with a
heat trace cable and lined with pipe insulation for further freeze protection. Silicone rubber drum
heaters have tension spring and hook fasteners. The heater jacket thermostatically controls water in
weather conditions down to -10°F (-23°C).
Supplies Required
• pipe sealant
• Air pressure equipment or supply
Check Contents
Separate all parts from packaging and check each part with Figure 2 and the parts list on page 6. Make sure
all parts are accounted for before discarding any packaging material. If any parts are missing, do not
attempt to assemble your Bradley 10-Gallon Tank until you obtain the missing parts.