Filter
Top Products
12
Water Connections continued-
Table Top Models (See Figure 3) The hot water outlet and cold water
inlet are identified on the back panel of the water heater. Referring to figure
3, remove the two screws that are holding the service access panel in place.
Remove front panel for access. Wedge a flat bladed screwdriver into the
front joint between the top and side panels and force the top panel upward.
This will separate the top panel from the water heater and allow further
access to the water heater.
Check drain valve to make sure that it is closed. Part the top fiberglass
insulation to allow access to the plumbing and electrical connections.
Connect the cold water supply line and hot water outlet lines using elbows,
nipples and unions as shown in the diagrams. Install a shutoff valve in the
cold water inlet. A listed temperature-pressure relief valve has been factory
installed. Plumb the discharge as shown.
Figure 3