Filter
Top Products
FlexiDome
XF & DN
| Installation Manual
Bosch Security Systems | 2005-10 | V1.0
EN | 26
Installer Settings
Install menu
Adjustment procedure DC-iris Lens:
1. Unlock the focus locking screw.
2. SET BACK FOCUS NOW is highlighted in the menu.
3. Turn the focus adjustment as required.
4. Lock the focus locking screw.
5. Exit the menu selection.
Install sync submenu
Note
VPHASE cannot be accessed if there is no valid locking signal.
Function Selection Description
SET
FOCUS
NOW
Forces the lens to fully open the iris. Adjust the
lens focus now.
COMM ON, OFF Bilinx communication ON/OFF
SYNC Select submenu Select to access the synchronization functions
CAMERA ID Select submenu Select to access ID menu
HEATER AUTO, OFF Select AUTO to enable the thermostatically
controlled heater function
DEFAULTS Select submenu Return all settings for all modes to factory defaults
EXIT Exit the menu
Function Selection Description
SYNC INTERNAL, LINE
LOCK
Select INTERNAL for free running camera
operation, select LINE LOCK to lock to the power
supply frequency.
DETECTED
SYNC
Shows the actual sync mode used by the camera.
VPHASE 0, 2, … 358 Adjusts the vertical phase offset (when in LINE
LOCK mode and a valid power supply frequency
is detected).
EXIT Return to the Install menu