Filter
Top Products
FlexiDome
XF & DN
| Installation Manual
Bosch Security Systems | 2005-10 | V1.0
EN | 25
Selecting an area
To set-up an area for BLC (or VMD), access the area menu by selecting the
AREA option from the BLC (or VMD) menu. Upon entering the AREA
menu, the current area is displayed with the upper left corner flashing. The
flashing corner of the image can be moved with the Up, Down, Left, Right
arrow keys. Pressing the Select key moves the flashing cursor to the
opposite corner, which can now be moved. Pressing Select again freezes
the area and exits the area menu.
Video Motion Detection (VMD) submenu
Note
If VMD areas overlap, motion is only detected in the area with the lowest
sequence number.
AREA Select submenu Select to access the Back Light Compensation
area menu (see selecting an area).
EXIT Return to Main menu
Function Selection Description
VMD OFF, SIL, OSD When VMD is enabled and the camera can
generate SIL (silent) or OSD (monitor alarm
generates on-screen message) motion alarms.
AREA 1, 2, 3, 4,
Select submenu
•It is possible to set 4 motion sensitive areas (per
MODE).
•Press SELECT to enter the area set-up menu.
ACTIVE ON, OFF Every area can be enabled individually by
selecting YES.
MOTION Press SELECT to
reset indicator
Indicates the peak of measured motion in the
selected area
SENS Use the LEFT/RIGHT keys to set the SENSitivity
for motion to the desired level. Motion above this
level triggers alarm.
EXIT Return to Main menu