Filter
Top Products
Bosch Security Systems | Version 1.1
DVR4C Remote Viewer | Operation Manual | Configuration Tool EN | 12
5.2.1 Information tab
The Information tab shows basic information about the
DVR.
5.2.2 Camera
Use this tab to set the video gain, brightness, and contrast
for the cameras connected to the DVR.
5.2.3 Recording
Use this tab to set the Normal Recording and Event
Recording parameters.
5.2.4 Event setup
Set the configuration of alarm inputs and the motion
detection in this tab.
5.2.5 Profiles
Use this tab to set the applicable periods for Weekday /
Weekend and day / night. Up to 30 exception days can be
configured.
5.2.6 System Settings
Use this tab to configure the various system settings.
5.2.7 Connectivity
Use this tab to set the DVR's network information; Ethernet
IP address, xDSL, PSTN and port settings.
> For more information, refer to the Network settings menu
of the DVR4C manual.
5.2.8 Disk manager
Disk setup
• When the Recording mode is set to Continuous (default),
the DVR overwrites older images when the hard disk is
full. When set to Linear, the DVR stops recording when
the hard disk is full and the administrator has to delete
video manually.
• Set a disk full warning percentage from 1 to 100%
(default 95%). A warning message is generated when the
used disk space exceeds the percentage set.
Block playback
• To block the playback of video that is older than a
certain time, select a period from the drop-down list.
This function is disabled by default.
5.2.9 Security tab
Use this tab to control access to the DVR. If you select IP
filtering, you can set up to ten IP address ranges that are
allowed or denied access to the DVR. The values you set
will normally depend on your network setup.
The IP address can be within a range from 000.000.000.000
to 255.255.255.255.