Filter
Top Products
D9412G/D7412G | Program Entry Guide | 2.0 9000MAIN EN | 51
Bosch Security Systems | 1/04 | 47775E
Area # Acct Is On
Default: See
Program Record Sheet
Selection:
Sixteen alphanumeric characters
Enter the text that displays when all areas sharing
the same account number are master armed. The
ACCT IS ON text appears at all command centers
assigned to these areas, if more than one area has the
same account number. The ACCT IS ON text also
appears if only one area in the system is used. See
the prompts
CC# Area Assign
and
Area # Acct Is
On
in Section 2.10.1 Cmd Cntr (Command Center)
Assignment. When all areas in the account are master
armed, the Area # Is On text is replaced by the
ACCT IS ON text if the area is armed before all the
areas with the same account number.
0101
0101
0101
A blank entry disables the ACCT IS ON
display for this area, allowing an account
wide area to display the AREA # IS ON
text instead of the ACCT IS ON text.
Each area can have unique ACCT IS ON
text, or you can program the same text in
each area of the account so when all the
areas in the account are armed, they all
show the same text.
0101
0101
0101
Although it is not programmed in this area,
the new D1260 Alpha V Command Center
can display up to sixteen characters for an
Area Name on line 1 of its display. The
Area Text (Area # Is Off, Area # Not
Ready, Area # Is On, and Acct # Is On)
programmed in this module appears on line
2 of the D1260 Alpha V Command Center.
When programming custom text, it should
be logical to users viewing it on the
D1260. For example, the Area Name Text
can be programmed to display Front
Office and the Area # Is Off text
(programmed in this section) could be
programmed to display Ready To Arm.
The D1260 would then show on line 1
Front Office and on line 2, Ready To
Arm.
2.10.3 Custom Function
Custom functions are a way to simplify use of
complex keystroke sequences entered at the
command center. These items are similar to speed
dialing on a telephone. A custom function can
automatically initiate an end user request by pressing
[ENTER] once the custom function text is displayed
on the command center. You can have up to sixteen
custom functions and restrict the use of these by area
and authority level.
Each
Custom Function ###
item has sixteen
characters of programmable text (
CF### Text
).
When the Custom Function is assigned to the menu
M## Function
(see Section 2.12 Function List) the
user can press [PREV] or [NEXT] to scroll to
CF### Text
. The user accesses the menu by
pressing [MENU] on the command center.
The user needs the appropriate authority level
enabled for the
L## C Function
128 to 143
in
Section 2.11 User Interface, to use the custom function.
Consider the scope of the command center used to
access the Custom Function. Each Custom Function
is enabled in the function menu by
M# CC Address
1 [through 8
]. If the Custom Function is not
assigned to a specific command center address, it
does not appear in the menu.
Custom Function
Default: 128
Selection:
128 to 143
Enter the Custom Function number you want to
program. You can program up to sixteen Custom
Functions, which are numbered 128 to 143.
CF### Text
Default: See
Program Record Sheet
Selection:
Sixteen alphanumeric characters.
See
Section 2.10.2 Area Text
for
valid character entries.
Determines the menu text displayed at the
command center for the custom function item. Use
this text to represent the functions performed by this
menu item.