Filter
Top Products
DINION capture 5000/7000 Installing the DINION capture | en 25
Bosch Security Systems, Inc. Installation Manual | 1.0 | 2012.01
operates as desired during darker conditions but overexposes
the image during sunny conditions.
IMPORTANT: Only setup Automatic Mode Switching if the
target license plate is in the sun and the captured image is
overexposed, never setup if the license plate is in the shade.
Mode Details
Mode 2 (FullSun) is two (2) gain points less than the normal
mode, by default. You can modify both mode settings as
needed in order to provide the desired image throughout the
day.
When modifying settings first verify which mode is active:
– Navigate to the Install menu (refer to
Section 4.1.2 Accessing Menu Keys, page 28).
– Access the Camera ID option and enable the Mode ID in
any preferred position.
– The active mode shows on the screen after a power cycle.
If changes are made to Mode 1 (Normal) ensure that the offset
change is made to Mode 2 (FullSun). For example, if the plate
image is too bright in Mode 1 (Normal) and you change the gain
from 8 to 6, then you should change the gain in Mode 2
(FullSun) from 6 to 4.
Important:
After changes are made to any settings ensure the DINION
capture is left in mode 1 under 'Mode' in the Main menu (refer
to Section 4.1 Menus, page 28).