Filter
Top Products
7
Owner’s manual and assembly instructions: 81000 portable outdoor heater 3/3/03
Contact 1-800-762-1142 for assistance.
Do not return to place of purchase.
Step 5–Center Lockup
• Slide the threaded portion of the large thumbscrew through the slot
in the center of the bracket mounted to the base.
• Thread the bottom bracket on to the thumbscrew with the round flat
rubber pads facing up.
• To mount the heater to a hole in your table, tilt the bottom
bracket/thumbscrew assembly until it fits through the hole.
Straighten the thumbscrew, and pull it up until the rubber pads
contact the underside of the table. Hand tighten only.
Note: If the hole in the surface you are mounting your heater to is less
than 1-1/2” in diameter, it will be necessary to center your heater over
the hole and slide the thumbscrew through the slot in the bracket and
the hole in the table. Attach the bottom bracket from underneath, and
tighten from the top with the thumbscrew.
Notice
Do not use tools to tighten the
thumbscrew. Hand tighten only. Do
not over tighten to prevent possible
damage to table surface.
Caution:
Before you attempt to use a propane
cylinder, understand all cylinder and
propane related precautions in Section
#1 – “Safety First.”
Step 6 – Gas Hook-up
Note: For best results, use heater with a 20 lb. cylinder.
The pressure regulator and hose assembly supplied with the
appliance must be used and replacements must be those specified
by the manufacturer.
To connect 20 lb. Cylinder
• Slip end of flexible gas line with brass fitting through center hole of
Base and up to threaded portion of regulator.
• Line up threads on fitting with those on regulator and rotate
clockwise until snug. HAND TIGHTEN ONLY. DO NOT USE ANY
HAND TOOLS TO MAKE THIS CONNECTION. BE CAREFUL NOT
TO CROSS THREADS WHEN SCREWING IN FITTING.
Note: if heater uses center clamp, hose can be routed through
opening in base and table.
• Set heater on base, making sure that flexible gas line is routed
through small slot in base.
• Attach gas line to cylinder by turning black plastic knob counter
clockwise into cylinder valve until tight.
Note: Be careful not to kink flexible gas line.
• When using the gas extension hose always locate the hose out of
pathways where people may trip over it or in areas where the hose
may be subject to accidental damage.
To connect 14.1 oz or 16.4 oz cylinder
Note: Some 1-lb cylinders may form frost when near empty.
• Line up threads on canister with those on regulator, insert and
rotate canister clockwise until they fit snugly together. HAND
TIGHTEN ONLY. BE CAREFUL NOT TO CROSS THREADS
WHEN SCREWING IN CANISTER.