Filter
Top Products
8
NOTICE:
Never leave the steam mop in one spot on any surface for any period of time.
Always place the steam mop on the resting mat (7) with the handle tube (4) in the upright
position when stationary and make sure the steam mop is turned off when not in use.
NOTICE: Always empty the water tank after use.
SmartSelect
TM
Dial - Fig. O
The steam mop is equipped with a SmartSelect
TM
dial (28) which shows various hard
floor surface cleaning applications. A light will glow next to the selected application. To
change the application, press and release the SmartSelect
TM
button (2) until the light
glows next to the correct operating mode for your particular hard floor surface.
NOTICE: Do not use on any unsealed hard floor surfaces. Additionally, on
surfaces that have been treated with wax or some no wax floors, the sheen may be
removed by the heat and steam action. It is always recommended to test an isolated
area of the surface to be cleaned before proceeding. We also recommend that you
check the use and care instructions from the floor manufacturer.
Using the SmartSelect
TM
button (2), choose from one of the following applications:
The steam mop will select the correct volume of steam required for your particular
cleaning operation.
NOTICE: SmartSelect
TM
has a memory. Switching the steam mop on will recall the
previously used setting.
STEAM BURST BUTTON
The steam burst button is a built in feature that aides in the removal of stubborn floor marks or
stuck on grime.
NOTICE: The steam burst will last for 10 seconds then the steam mop will return to
the chosen setting.
NOTICE: This unit will kill 99.9% of bacteria and germs when used in accordance with
this manual and with the micro fiber pad fitted and a continuous run time of 90 seconds.
HINTS FOR OPTIMUM USE
GENERAL USE
CAUTION: Never use the steam mop without first attaching a cleaning pad.
WARNING: It is important to monitor the water level in the water tank. To refill the
water tank and continue to sanitize/ clean, see Filling the Water Tank section.
CAUTION:
Never leave the steam mop in one spot on any surface for any period of
time. Always place the steam mop on the resting mat (7) with the handle tube in the upright
position when stationary and make sure the steam mop is turned off when not in use.
• Alwaysvacuumorsweepthefloorbeforeusingthesteammop.
slowly, covering a small area at a time.
Donotusechemicalcleanerswithyoursteammop. To remove stubborn stains
from vinyl or linoleum floors, you can pre-treat them with a mild detergent and some
water before using the steam mop.
STEAM MOP CLEANING
Raise the steam mop off the resting mat and lightly press it down onto the cleaning pad.
23
2
28
O