Filter
Top Products
OPERATION
SWITCHING ON AND OFF - Fig. J
CAUTION: FOR FLOOR USE ONLY;
DO NOT USE THE UNIT UPSIDE DOWN.
NOTICE:
When the steam mop is first
turned on the water reservoir will glow red.
reservoir will glow blue.
It takes approximately
15 seconds for the steam mop to heat up.
NOTICE:
Never leave the steam mop in one spot on any surface for any period of time.
Always place the steam mop on the resting mat (7) with the handle tube (4) in the upright
position when stationary and make sure the steam mop is turned off when not in use.
NOTICE: Always empty the water tank after use.
SmartSelect
TM
Dial - Fig. K
The steam mop is equipped with a
SmartSelect
TM
dial (20) which shows various
hard floor surface cleaning applications.
A Light will glow next to the selected
application. To change the application, press
and release the SmartSelect
TM
button (2)
repeatedly until the light glows next to the
correct operating mode for your particular
hard floor surface.
NOTICE: Do not use on any unsealed
hard floor surfaces. Additionally, on surfaces
that have been treated with wax or some no
wax floors, the sheen may be removed by the heat and steam action. It is always
recommended to test an isolated area of the surface to be cleaned before proceeding.
We also recommend that you check the use and care instructions from the floor
manufacturer.
Using the SmartSelect
TM
button (2), choose from one of the following applications:
The steam mop will select the correct volume of steam required for your particular
cleaning operation.
NOTICE: SmartSelect
TM
has a memory. Switching the steam mop on will recall the
previously used setting.
STEAM BURST BUTTON - Fig. K
The steam burst button is a built in feature that aids in the removal of stubborn floor marks or
stuck on grime.
NOTICE: The steam burst will last for 10 seconds then the steam mop will return to
the chosen setting.
7
20
K
J