Filter
Top Products
ATTACHING A CLEANING PAD - Fig. D
Replacement cleaning pads are available from
your Black & Decker dealer (cat. no. SMP20).
floor with the ‘hook & loop’ side facing up.
(7) and press it down onto the cleaning pad
(6). You are now ready to steam clean and
sanitize your floor.
NOTICE: Always place the steam mop on
the resting mat (7) with the handle tube (4)
in the upright position when stationary and
make sure the steam mop is turned off when
not in use.
REMOVING A CLEANING PAD - Fig. E
CAUTION: Always wear suitable shoes
when changing the cleaning pad on your
steam mop. Do not wear slippers or
open-toed footwear.
wait until it cools down. (approximately five
minutes)
Place the front of your shoe onto the cleaning
pad removal tab (14) and press down firmly.
NOTICE: Always place the steam mop on
the resting mat (7) with the handle tube (4) in the upright position when stationary and
make sure the steam mop is turned off when not in use.
ATTACHING THE CARPET GLIDER - Fig. F
Place carpet glider on the floor.
Lightly press the steam mop with attached
cleaning pad down onto the carpet glider (8)
until it clicks into place.
NOTICE: Always place the steam mop on
the resting mat (7) with the handle (4) in the
upright position when stationary and make sure
the steam mop is turned off when not in use.
REMOVING THE CARPET GLIDER
CAUTION: Always wear suitable shoes
when changing the carpet glider on your
steam mop. Do not wear slippers or open-toed footwear.
five minutes)
Lift the steam mop up off the carpet glider.
NOTICE: Always place the steam mop on the resting mat (7) with the handle (4) in the
upright position when stationary and make sure the steam mop is turned off when not in use.
5
F
D
E