Black & Decker BD200MTB Vacuum Cleaner User Manual


  Open as PDF
of 44
 
7
Installing/Removing Accessories
BD200TMT Oscillating Tool is specifically designed to work with Black & Decker
accessories, but is also
compatible with many manufacturers’ accessories. If unsure,
confirm
with the specific manufacturer that their accessory is compatible.
CAUTION: To avoid injury, do not use any accessory for an application where the
bolt and clamp washer may fail to hold the accessory.
CAUTION: Read and follow all manufacturers’ safety warnings for any accessories
used with this tool.
CAUTION: To avoid injury, ensure adapter and
accessory are securely tightened.
•Cleananyresidualdebrisfromthetoolshaftandthe
accessory holder.
•Positiontheaccessorysotheworkingedgeisaway
from the tool as shown in Figure 1.
•Placetheaccessoryonthefrontoftheoscillatingtool,
ensuring the accessory fully engages the pins.
•Placethewasher(D)overtheaccessorywiththe
grooved side covering the pins.
•Slidethebolt(E)throughthewasherintotheoscillating
toolandtightenwiththehexwrench(F).
•Toremove,loosentheboltandwasherwiththehexwrenchandremovethe
accessory.
•Toattachthesandingplaten,loosentheboltenoughtoslidetheplatenunderthe
washer(D),ensuringtheplatenfullyengagesthepins.Slidethehexwrench(F)
through the hole in the platen and tighten the bolt (E).
Assembly (BD200MT)
WARNING: Disconnect the plug from the power
source before making any assembly, adjustments or
changing accessories. Such preventive safety
measures reduce the risk of starting the tool
accidentally.
WARNING: Risk of lacerations or burns. Do not
touch workpiece or blade immediately after operating the
tool. They can become very hot. Handle carefully. Always
allow workpiece and accessories to cool before handling.
Installing/Removing Accessories
TheBD200MTfeaturesanexclusivetool-freeaccessory
changing system. This allows for faster accessory
changeswithouttheneedforwrenchesorhexkeyslike
other oscillating tool systems.
•Graspthetoolandsqueezetheaccessoryclamping
lever (Figure 2).
•Cleananyresidualdebrisfromthetoolshaftandthe
accessory holder.
•Positiontheaccessorysotheworkingedgeisaway
from the tool as shown in Figure 3.
•Slidetheaccessorybetweentheshaftandthe
accessory holder making sure the accessory fully
engages the pins on the holder and is flush with the
shaft.
•Releasetheaccessoryclamplever.
2
3
1
D
E
F
 previous next