Bissell 8806 Vacuum Cleaner User Manual


 
7
Using the Measuring Cup, pour BISSELL Deep Cleaning
Formula into the mouth of the bladder.
Fill to the bottom of the neck with hot tap water. Do not
boil or microwave water.
NOTE: Fill slowly to reduce sudsing.
Replace the Tank Lid, matching the Lid and Tank edges.
Rotate the handle to carrying position. Replace Tank
in machine base, seating firmly in place. Rotate
handle back down to latched position.
NOTE: Remove the Tank-in-Tank, following
steps 1 through 3 on page 6 .
Pour out dirty water.
After each use, remove and rinse the Lint Screen located
on the Tank Lid.
Remove Tank Lid, follow step 3 on page 6.
Remove Lint Screen. Rinse under faucet to
remove any debris.
Insert Lint Screen back in Tank Lid. The
screen will click into place.
Replace Tank Lid.
Refill with cleaning solution and clean tap water, follow
steps 4-5 above.
NOTE: When a cleaning job is complete, rinse out the
Tank-in-Tank by running clean water between the
bladder and the tank.
Return the Tank-in-Tank to the machine, follow
step 6 above.
Refer to the Maintenance/Storage section on the
next page for final cleanup.
To Fill The Tank-in-Tank (Continued)
5.
6.
1.
2.
When It's Time To Empty The Tank-in-Tank
3.
4.
5.
B.
D.
4.
4
5
6
Latched
Lint Screen
1
2B
5
Tip:
A special red float device in the tank
will cause the cleaner to stop remov-
ing solution from the carpet. The motor
sound will rise in pitch to let you know
the dirty water tank is full.
2C
Lint Screen
A.
C.
ug310-5907_1692-1694_205.indd 7ug310-5907_1692-1694_205.indd 7 4/18/05 9:19:56 AM4/18/05 9:19:56 AM