Bissell 8806 Vacuum Cleaner User Manual


 
Maintenance/Storage
CAUTION:
PowerSteamer
uses water and
must not be stored
where there is a
danger of freezing.
Freezing will
damage internal
components and
void the warranty.
2
3
4
5
6
7
9
Turn Power switch OFF.
Unplug power cord from the outlet and coil around
Power Cord Quick Release.
Remove and rinse tools in clean, running water, let
dry and replace in tool caddy.
Coil flex hose through storage brackets.
Remove Tank-in-Tank,
dispose of dirty water. See
The Basics section, on page 6.
Rinse out the Tank-in-Tank
and reseat the tank unto the
machine.
Wipe all exterior surfaces with a soft cloth.
Store cleaner upright in a protected, dry area.
When carpet is dry, vacuum again to remove hair and fuzz that
the POWERSTEAMER may have loosened.
Turn the machine off and unplug from wall outlet.
Step on the release pedal and recline the handle down onto
floor.
Remove the Tank-in-Tank. Set them aside.
Remove Belt Access Door located near the ReadyTools Dial. Insert a
flat head screwdriver into the slot nearest to the handle and gently
prying the access door off.
Turn the machine onto its side so the belt access area is
facing upward.
On the bottom of the machine, near the belt access area, is a
Red Retainer Plate that holds the black brush arm and brush
in place. Using a Phillips head screwdriver remove the screw
that holds the Red Retainer Plate in place. Set Red Retainer
Plate and Phillips head screw aside.
NOTE: For 1693 Model series, remove stationary brush
(skip step 6 and 7)
Remove the black brush arm that holds the brush in place.
Set the black brush arm aside.
Remove the “toothed” Brush Belt from the Brush then from the
Red Pump Pulley. Set the “toothed” Brush Belt and Brush aside.
Locate and remove the broken Pump Belt.
1.
2.
3.
5.
6.
6.
7.
1.
2.
3.
4.
7.
8.
Pump Belt and Brush Belt Replacement
4.
5.
8.
9.
9.
Power Cord
Quick Release
Flex Hose
Storage Bracket
8
11
WARNING:
To reduce the risk
of fire, electric
shock or injury
unplug from outlet
before servicing.
ug310-5907_1692-1694_205.indd 11ug310-5907_1692-1694_205.indd 11 4/18/05 9:20:04 AM4/18/05 9:20:04 AM