Filter
Top Products
16
www.bissell.com
Attach vacuum hose and tools continued
7. Place the TurboBrush in the bracket by aligning
the bottom of the bracket with the opening of the
brush roll and snap the TurboBrush into place.
Handle position
Press the handle release pedal with your foot to
place your BISSELL PowerForce Turbo Bagless
into one of three cleaning positions.
1. Upright- For storage and above floor
cleaning with special tools.
2. Normal Cleaning- Press handle release
pedal once. Use for most household floor
cleaning tasks.
3. Low Cleaning- With the vacuum in normal
cleaning position, press handle release pedal
again. Use for reaching under low furniture
such as tables, chairs and beds.
Powerfoot height adjustment
The powerfoot/rotating floor brush on your BISSELL
PowerForce Turbo Bagless can be adjusted to clean
several floor surfaces.
NOTE: For optimal cleaning performance,
adjust to the lowest practical setting. If
your cleaner is difficult to push, adjust to
the next higher setting.
1. Place handle in upright position.
2. Turn height adjustment knob to desired setting.
Lowest Setting - For bare floors.
Medium Settings - For short and medium
pile carpets.
Highest Setting - For plush pile carpets.
3. Place the handle into the normal cleaning
position and the powerfoot will adjust to the
setting chosen.
NOTE: You may also adjust the setting while
in the normal cleaning position.
Transporting cleaner
1. To move your cleaner from room to room, put
the handle in the upright position, tilt the cleaner
back on its rear wheels and push forward.
2. The cleaner can also be moved by using the
carrying handle on the back.
Assembly
Operation
6
CAUTION:
Before using your vacuum, make
sure that the dirt container is in
locked position and that all filters
(inner circular, outer circular,
pre-motor and post-motor) are
in place. Do not operate your
vacuum without these filters.
Tip:
Your vacuum features
a Quick Release cord
wrap. To remove the
power cord quickly
and easily, rotate
the upper cord wrap
towards the floor, and
slip power cord from
upper and lower
cord wraps.
Tip:
Before cleaning under
low furniture, check
area first for objects
that might harm the
unit or block the
vacuum hose.
1
2
3
ATTENTION:
Some Berber carpets have a tendency to fuzz
with wear. Repeated strokes in the same
area may aggravate this condition. Consider
setting your cleaner on a higher than normal
setting for this type of carpet.
Carrying
Handle
ug110-4049_82H5_1008.indd 6ug110-4049_82H5_1008.indd 6 10/14/08 2:39:57 PM10/14/08 2:39:57 PM