Filter
Top Products
12
www.bissell.com
Replace light bulb
Use only BISSELL replacement bulbs in your
BISSELL PowerForce Turbo Bagless.
1. Unplug cleaner from electrical outlet.
2. Using a flat screwdriver, table knife or coin,
insert into the slot on the right of the lens
and gently push inner latch to the left, as
shown, to remove the lens.
3. Remove the bulb from the socket by grasping
bulb and pulling straight out. Install the new bulb
by pushing it gently into the socket until the bulb
snaps into place.
5. Reposition lens by inserting tab on left side and
then pushing the right side back into place.
Clearing clog
Low suction, poor pickup or no suction may be
due to a clog in the vacuum cleaner. If you notice
a change in the sound of the vacuum motor or a
reduction in the spinning action in the dirt
container, check for clogs.
1. Unplug cleaner from electrical outlet.
2. Empty dirt container.
3. Check upper tank and primary separator for
build up or clogs. Check to make sure primary
separator is installed correctly. To unlock the
primary separator, grasp the rim and turn
toward the left. Pull straight down to remove.
If the primary separator is missing or not
locked into place, check and clear the tube in
the center of the dirt container and properly
install primary separator.
4. Remove the Twist ‘n Snap hose from the
vacuum by turning to the left. Check the
suction inlet, hose and hose wand for clogs.
Remove any clogs from the hose using a
long, narrow object such as a broomstick.
5. Check the foot hose for clogs. If needed,
remove the screw attaching the hose wand
base to the vacuum. Straighten the foot hose
and unclog with a long, narrow object such
as a broomstick.
6. If the clog persists, follow the instructions for
checking the rotating floor brush on page 11
and inspect the air passageway for obstructions.
Maintenance and care
Air Passageway
Suction
Inlet
Primary Separator
Hose Wand
Base
ug110-4049_82H5_1008.indd 12ug110-4049_82H5_1008.indd 12 10/14/08 2:40:50 PM10/14/08 2:40:50 PM