Filter
Top Products
www.bissell.com 800.237.7691
Maintenance and care
12
The post-motor HEPA Media Filter*
assists in the filtration process to
return clean air to the room. Use only
BISSELL replacement filters in your
PowerGroom Multi Cyclonic.
1. Turn the power OFF. Unplug the vacuum
from the electrical outlet.
2. The post-motor filter is located behind
the door labeled “FILTER” on the rear of
the vacuum. Open the door by pushing
down on the tab of the door and pulling
out to remove.
3. Remove the post-motor HEPA Media
Filter* by grasping the handle on the
filter and pulling out to remove.
4. Replace the post-motor HEPA Media
Filter* with a new filter.
NOTE: The post-motor filter is a
white, pleated HEPA Media Filter*.
This filter is NOT washable and must
be replaced when it becomes dirty.
5. Replace the filter door by inserting the two
tabs at the bottom of the filter door. Then
push down on the tab on the door and
push it back into the vacuum. Release the
tab on the door to lock into place.
* The filter media, not the vacuum as a whole,
complies with the IEST-RP-CC001.5 or the
EN-1822-1:2009 HEPA standard.
Thermal protector
An internal thermal protector has been
designed into your vacuum to protect
it from overheating. When the thermal
protector activates, the vacuum motor
will stop operating. If this happens:
1. Turn the cleaner OFF (O) and unplug
from electrical outlet.
2. Empty dirt container, check filters and
air passages for dirt accumulation.
3. The thermal protector automatically
resets after approximately 2 hours.
If the thermal protector does not reset,
call BISSELL Consumer Services or visit
the website.
Replacing the Post-motor HEPA Media Filter*
Post-Motor HEPA
Media Filter*
3.
4.