Filter
Top Products
Bissell PowerSteamer® ProHeat™ Series Service Center Repair Guide
Printed February, 2001
1/30/2004 (Revision 1)
11
13. Attach the "hot" and "neutral" terminals onto the new motor.
14. Turn the motor so that the "ground" terminal is oriented downward.
15. Loop the wires around the bottom of the motor, then out the three motor vents at the rear
of the motor cradle (NOT where the shaft comes through).
16. Tilt the fan side of the motor up and insert the gasket into the bottom motor housing.
17. Replace motor cover. Gently rock into place until straight. Pull out on the tab at the motor
duct end of the motor cover and guide it past the gasket.
18. Replace the four screws in the motor cover.
19. Replace the motor duct by placing the tab in first, then twisting and pivoting it into
position.