Bissell 7901 Vacuum Cleaner User Manual


 
13
(Available on select models only)
The Perfect Pass feature is designed to help you achieve the best
cleaning results when deep cleaning.
Apply smooth even strokes when deep cleaning your
carpets. An upright deep cleaner should not be used at
the same speed as an ordinary vacuum. That is too fast
for optimum cleaning results.
The Perfect Pass indicator displays a red light which tells
you if you are in the range of Best Cleaning or if you
are going Too Fast. If you notice consistently that the
indicator light is in the Too Fast area, slow down until
the light is in the Best Cleaning range. This will ensure
you are getting the best cleaning results.
(Available on select models only)
Unplug cleaner from the outlet before attaching TurboBrush. Attach
TurboBrush to the flex hose by pressing tool onto the grip/trigger
until button snaps into hole. Make certain tool is securely in place.
Move the TurboBrush switch to the “BRUSH” position.
This activates the brush when the unit is running.
Place the tool directly on the soiled surface. Apply
downward pressure on the tool and pull towards you
while pulling trigger to spray cleaning solution.
Release the spray trigger and move the switch to the
SUCTION” position. Vacuum the area until no more
cleaning solution can be removed.
Repeat steps 1-3 until no more dirt can be removed.
Caution: Do not overwet.
Disconnect the TurboBrush from the flex hose by pushing
down on the button lock and pulling straight off.
Once removed from the flex hose, the TurboBrush can be
cleaned.
A) Move the switch to the “SUCTION” position
B) Rinse under running water.
C) Check spray nozzle for dirt. If necessary, clean with
a soft bristle brush.
D) Replace TurboBrush in its special storage
location on the handle front. (on select models only
1.
2.
3.
4.
TurboBrush
®
Assembly
Use
When You’re Done
1.
2.
Perfect Pass
BRUSH
SUCTION