Bissell 7901 Vacuum Cleaner User Manual


 
11
Carpet Cleaning
1.
2.
3.
4.
5.
6.
7.
ATTENTION
BERBER CARPET
OWNERS:
Some Berber Carpets have a
tendency to fuzz with wear.
Repeated strokes in the
same area with an ordinary
vacuum or deep cleaner may
aggravate this condition.
Please see Stain Removal
instructions on page 12.
Plug into a proper outlet and turn the Power and the
SmartTemp switches ON. Wait two minutes for the
heater to warm up before beginning to clean.
While pressing the trigger, make one slow forward wet
pass and another one back. Let the SmartTemp heated
formula and DirtLifter Powerbrush do the work for you.
Caution: Do not overwet.
Note: Take care not to run over loose objects or
edges of area rugs. Stalling brush may
result in premature belt failure.
Release the trigger and make one slow forward and back
pass over the same area to remove any residual dirty water.
Repeat cleaning passes until solution being pulled up
appears clean.
Continue passes without pressing the trigger until you
can’t see any more water being pulled up.
Note: Both the SmartMix and the clean water
tank must have liquid in them in order for
the machine to spray. If one tank is empty
the machine will not apply either cleaning
solution or water only.
After cleaning, you may want to turn the SmartMix dial to
the Water Rinse/Carpet Protector setting to give your
carpeting a final rinse. This will ensure thorough removal
of embedded dirt loosened by the Advanced Deep
Cleaning Formula. BISSELL Advanced Cleansing
Formulas contains an anti-resoiling agent that helps your
carpets repel dirt and keeps them looking good longer.
When the cleaning job is complete refer to the
Maintenance section for machine cleanup and storage
instructions on page 17-19.