Filter
Top Products
Getting Ready (continued)
3. Remove the collection tank from the unit by
opening the Quick Release Hose Door and
lifting the tank straight up by the handle.
4. Remove the top lid from the collection tank
and set aside.
5. Fill the collection tank to the fill line (located
on side of tank) with clean, cold water.
6. Replace the top lid back onto the top of the
collection tank
7. Set the collection tank back in the machine
8. Select "WATER FILTER VACUUM" with the
mode selector.
9. Close the Quick Release Hose Door tightly
until it clicks into the locked position.
10. Plug into a proper outlet and press the ON/
OFF button down into the ON position.
Emptying the tank
1. Open the Quick Release™ Hose Door and
remove the collection tank by lifting straight
up with the tank handle.
2. Remove the top lid from the collection tank
and set it aside.
3. Empty dirty water into a sink or toilet, or
outside. Pour the dirty water out from the cor-
ner of the tank. Rinse out the tank thoroughly.
4. Refill the tank if needed and replace the top lid
back onto the top of the collection tank.
5. Set the collection tank back in the machine.
6. Close Quick Release hose door tightly until it
clicks into locked position.
7. If finished vacuuming, refer to the Maintenance
and care section starting on page 14.
Wet cleaning
Before you clean
1. Plan activities to give your carpets time to dry.
2. Thoroughly dry vacuum the area to be cleaned.
3. Plan your cleaning route to leave an exit
path. It is best to begin cleaning in the
corner farthest from your exit.
Operation
9
www.bissell.com
34
56
78
ug120-4005_7700_607.indd 9ug120-4005_7700_607.indd 9 6/28/07 10:05:48 AM6/28/07 10:05:48 AM