Filter
Top Products
11
www.bissell.com
Operation
Carpet Cleaning (continued)
7. Continue to clean entire carpet working in
one meter by one meter sections.
8. If machine loses suction, stop spraying and
check the collection tank level. Empty if
necessary.
9. If the machine stops spraying turn off
wet clean button immediately and check the
solution tank level.
NOTE: Never run in wet clean mode when
the clean water formula tank is dry or
missing.
When you are finished
1. Turn off the heater, wet clean,
and power buttons.
2. Remove the collection tank from the unit by
opening the quick release hose holder and
lifting the tank straight up by the handle.
3. Remove the top lid from the collection tank
and set it aside.
4. Empty dirty water into a sink, toilet or outside.
Pour the dirty water out from the corner of the
tank. Rinse out the tank thoroughly.
NOTE: You may leave the solution tank with
water and formula in it so you are ready for
the next use.
6. Allow all parts to dry before storing.
Hard floor cleaning
1. See “Getting Ready to Wet Clean” on Page 10.
2. Be sure to use BISSELL Hard Floor Solutions
in the solution tank for hard floor cleaning.
Fill the formula tank by first unscrewing the
measuring cap. Always use genuine BISSELL
formulas to maximize cleaning and for the
safety of your machine. Fill tank to fill line
with hot tap water. Add one full cap of formula.
Screw measuring cap tightly back onto the
solution tank.
3. Set the solution tank back in the machine.
23
2
ug120-4005_7700_607.indd 11ug120-4005_7700_607.indd 11 6/28/07 10:05:56 AM6/28/07 10:05:56 AM