Filter
Top Products
While Wet Cleaning, you will see dirty water
collected in the Dirty Tank. When the Tank is full,
the white Float in the Dirty Tank will rise to the
top, making a noticeable sound to let you know
it is time to empty the Dirty Tank. Suction will
stop when tank is full of water.
Remove the Dirty Tank Lid. Then dump the dirty
water and debris into the sink, toilet, laundry tub
or outside. Rinse the tank out with warm water
and replace it in the unit.
While the Dirty Tank is out of the unit, remove the
Pleated Filter from the top of the tank. Remove
dirt and debris from the pleats by gently tapping
the filter over the wastebasket or outside.
The Pleated Filter can also be rinsed under water
to clean.
NOTE: If the Pleated Filter is rinsed with
warm water to clean, it is recommended
to leave it out of the unit to air dry before
placing it back in the unit.
Gentle Clean™Brush
Remove the Brush from the unit and rinse under
warm water.
Gentle Clean™Pad
Remove the Gentle Clean™ Pad Plate from the
unit. Peel the pad from the Pad Plate and toss in
the wash!
Remove the Wet Clean Nozzle by pulling tab on
right and left side of nozzle. Rinse any dirt and
grime off the nozzle under warm tap water.
To replace the Wet Clean Nozzle, insert the 4
tabs along the bottom of the Nozzle Window
and gently snap the Wet Cleaning Nozzle back
into place.
Dirty Tank Is Full
When You're Finished
Emptying The Dirty Tank
Removing Wet Clean Nozzle
9
www.bissell.com 800.237.7691
Checking The Filter
Cleaning The Gentle Clean
™
Brush or Pad
WARNING:
To reduce the risk of
fire, electric shock or
injury unplug from outlet
before servicing.
Tip:
If there are large pieces of
debris in the water, you may
not want to empty the tank
into your sink.
Tip:
While using the Flip-It in the
Wet Cleaning mode, make
sure to listen for the change
in the sound to alert you
when the Dirty Tank is full.
ug603-6704_5200_306.indd 9ug603-6704_5200_306.indd 9 3/1/06 11:29:04 AM3/1/06 11:29:04 AM