Filter
Top Products
16
w ww.b is se ll .c a 1 8 00 2 63 -2 53 5
5. Clean strings, hair and other debris from
rotating floor brush, paying particular
attention to brush ends.
6. Clean strings, hair and other debris from motor
pulley and drive belt areas.
7. Check drive belt carefully for wear, cuts or
stressed areas. Replace if worn.
8. Check air passageway for obstructions.
Remove debris from this area.
Replace drive belt
Use only BISSELL Style 7 Replacement Belts
(#32074) in your BISSELL PowerForce.
1. Unplug cleaner from electrical outlet.
2. With rotating floor brush removed from vacuum
cleaner (Steps 1-4 of Check rotating floor brush
and drive belt), grasp old drive belt and remove
from motor pulley. Discard old drive belt.
3. Place new drive belt over motor pulley and
stretch other end over rotating floor brush in
the space between the bristles.
4. Place ends of rotating floor brush down into
slots on sides as shown.
5. Turn rotating floor brush by hand several
times in direction of motor pulley. If properly
installed, drive belt will center itself.
6. Reposition brush cover and four screws.
Tighten screws securely. Make sure end of
brush cover is snapped into place.
Replace light bulb (select models)
Select models are equipped with a headlight.
Use only BISSELL Replacement Bulbs in your
BISSELL PowerForce.
1. Unplug cleaner from electrical outlet.
2. Insert a flat screwdriver or coin into the
slot on the right of the lens and gently push
inner latch to the left as shown to remove
the lens.
3. Remove the bulb from the socket by grasping
bulb and pulling straight out. Install the new bulb
by pushing it gently into the socket until the bulb
snaps into place
4. Reposition lens, by inserting tab on left
side and then pushing the right side back
into place.
Maintenance and care
9
Motor Pulley
Air Passageway
Brush
Cover
Press here
Check rotating floor brush and drive belt (continued)