Filter
Top Products
Clearing clog
The Hose on the back of the vacuum cleaner
that carries the dirt from the powerfoot to the
dust bag can sometimes become clogged. If
you notice a change in the sound of the vacuum
motor, check for clogs.
1. Unplug cleaner from electrical outlet.
2. Pull the bag door outward to open and set
aside. Remove the dust bag to check the
suction Inlet for a clog.
3. Grasp the quick reach handle and lift up to
separate from the suction intake opening.
Check for a clog in the base, the wand or the
hose.
4. Release the hose from the vacuum by
turning to the right. Straighten the hose and
unclog with a long, narrow object.
5. If the clog persists, turn the vacuum cleaner
OFF and unplug it. Remove the brush cover.
Check the air passageway for obstructions.
Remove debris from this area. Reposition
brush cover and four screws. Tighten screws
securely. Make sure end of brush cover is
snapped into place.
10
w ww.b is se ll .c a 1 8 00 2 63 -2 53 5
Maintenance and care
Air Passageway
Troubleshooting
Vacuum cleaner won’t turn
Possible causes Remedies
1. Power cord not firmly plugged in 1. Check electrical plug
2. Blown fuse/tripped breaker 2. Check/replace fuse or reset breaker.
Vacuum cleaner won't pick up dirt
Possible causes Remedies
1. Incorrect height adjustment 1. Adjust powerfoot to correct height setting
2. Hose not attached to suction opening 2. Grasp hose grip and firmly push onto the base
3. Twist 'n Snap hose not securely attached
3. Make sure Twist 'n Snap hose is snapped
into position
4. Dust bag is full 4. Replace with new dust bag
5. Rotating floor brush bristles worn 5. Replace brush
6. Rotating floor brush jammed
6. Remove brush and clean debris from
brush ends
7. Clog in vacuum 7. Follow instructions for clearing clogs
WAR NING:
To reduce the risk of
electric shock, turn power
OFF and disconnect
polarized plug from
electrical outlet before
performing maintenance
or troubleshooting.
Suction Inlet