Filter
Top Products
www.bissell.com 800.237.7691
Assembly
5
2.
2.
The only tool you’ll need to
assemble your vacuum cleaner
is a Phillips head screwdriver.
Attach handle to vacuum
1. Locate the vacuum handle and
remove the screw packet taped to
the base of the handle.
2. Stand the vacuum upright and
slide the base of the handle firmly
into the grooves at the top of the
vacuum body.
3. Check to be sure the handle is fitted
to the vacuum body. If there is a gap
in front, continue to push firmly until
the handle is flush.
4. Insert the screw provided from the
screw packet into the existing hole.
Tighten securely with a screwdriver.
Attach vacuum hose and tools
1. Attach the Twist ‘n Snap™ hose by
lining up the tabs on the base with
the corresponding notches on the
back of the vacuum.
2. Turn the Twist ‘n Snap hose to the
right to lock the hose into place.
3. Grasping the Quick Reach handle,
slide the end of the hose wand
onto the hose wand base. Snap
the hose into the hose clip.
NOTE: The powerfoot will not
suction properly unless the hose
wand is firmly attached.
4. Snap the extension wand and the
crevice tool together into the storage
clip. The crevice tool stores inside
the extension wand and snaps onto
the back of the unit.
5. Snap the combination tool into the
storage clip.
6. Attach the TurboBrush Tool by
aligning the small holes near the
brush roll with the tabs at the
bottom of TurboBrush Tool housing.
Snap TurboBrush Tool into place.
6.
4.
3.
4.
4.
5.