Filter
Top Products
Operations
7
www.bissell.com
Power cord
The power cord is located at the rear of the
vacuum. Gently pull out the power cord,
watching for the yellow line. Stop pulling the
power cord once the yellow line is visible.
There is also a red line, which indicates the
end of the usable cord. Do not pull the power
cord out beyond the red line.
Automatic cord rewind
Your vacuum is equipped with an automatic
cord rewind. When cleaning is finished, press
the power button OFF and grasp the plug to
disconnect from the electrical outlet. Hold the
plug and press the automatic cord rewind
button to rewind the cord automatically.
Power button
Turn the power on or off by pressing lightly
downward on the power button ( ).
Motorized powerhead
Set the power switch on the handle to 1 for
rotating brush or 0 to turn rotating brush off.
NOTE: The power brush will automatically
turn off if the telescopic tube is in an upright
position to protect your carpet from potential
damage caused by the rotation of the power
brush.
NOTE: The power brush will automatically
turn off if the rotator bar is blocked by clogs
(hair, cloth, ect.) for your protection. In that
case, turn off the power head, unplug the
vacuum, clean the clog, and re-start the
power brush.
Variable suction power control
The variable suction power control is located
on the top of the handle. Slide the control
toward the larger dots for maximum suction.
Slide the control toward the smaller dots to
minimize suction for lightly soiled areas or
delicate fabrics.
Power Button
CAUTION:
Be careful to avoid
injury as cord retracts
very quickly.
CAUTION:
Before using your vacuum,
make sure that the dust bag
and all filters (pre-motor
and post-motor) are in
place. Do not operate your
vacuum without the dust
bag and filters.
Automatic
Cord Rewind
Button
Variable Suction
Control
PowerBrush
On/Off
ug110-4075_48K2_1208.indd 7ug110-4075_48K2_1208.indd 7 12/22/08 10:16:24 AM12/22/08 10:16:24 AM