Filter
Top Products
Bag change indicator
The bag change indicator is located below
the swivel hose. If the bag change indicator
turns orange while you are vacuuming, the
dust bag needs to be replaced. The dust bag
may appear to be full or only partially full
depending upon the type of debris picked up.
Fine particles can block the airflow in the dust
bag and reduce suction before the dust bag
is full. If the bag change indicator remains
orange, even after changing the dust bag,
turn the vacuum off and check for a clog in
the hose or tools.
Replace dust bag
Never reuse a dust bag. Use only BISSELL
replacement dust bags in your Zing Bagged
canister vacuum.
1. Turn the power OFF ( ). Unplug the
vacuum from electrical outlet.
2. Disconnect the flex hose by turning
the hose cuff counterclockwise.
3. Open the dust bag compartment
by lifting up on the latch located
underneath the carry handle.
4. Remove the dust bag by sliding the
cardboard dust bag cuff out from the
bag holder grooves. Dispose of the
used dust bag.
5. Using a new dust bag, align the card-
board dust bag cuff with the bag holder's
black grooves. Slide the bag cuff into the
grooves with the black arrow pointing up.
NOTE: The bag holder pivots up
and down. Before closing the
vacuum tank, make sure the dust
bag is securely placed and the bag
holder is in the down position.
6. Close dust bag compartment door and
press down gently until it locks into place.
NOTE: The dust bag
compartment will not close
without the vacuum bag
in place.
7. Reconnect the flex hose.
www.bissell.com 800.237.7691
7
Maintenance and care
3.
4/5.
WARNING:
To reduce the risk of electric shock,
turn power switch OFF and dis-
connect plug from electrical outlet
before performing maintenance or
troubleshooting checks.
Bag Change
Indicator