Filter
Top Products
12
Use only BISSELL Replacement Belts in your BISSELL Lift-Off.
Style 8 Drive Belt (2 pack) #3200.
Unplug cleaner from electrical outlet.
With Rotating Floor Brush removed from vacuum cleaner (Steps 1-5
of Check Rotating Floor Brush and Drive Belt), grasp old Drive Belt
and remove from Motor Pulley. Discard old Drive Belt.
Place new Drive Belt over Motor Pulley and stretch other end over
Rotating Floor Brush in the space between the bristles.
Place ends of Rotating Floor Brush down into slots on sides as shown.
Turn Rotating Floor Brush by hand several times in the direction of
Motor Pulley. If properly installed, Drive Belt will center itself on
Rotating Brush crown.
Reposition Brush Cover and screws. Tighten screws securely.
Replace Drive Belt
1.
2.
3.
4.
5.
6.
ug603-5539_3750E_304 6/25/04 2:08 PM Page 12