Filter
Top Products
10
Use only BISSELL Replacement Filters in your BISSELL Lift-Off.
Upper Tank Filter 203-1085
Unplug the cleaner from electrical outlet.
The Upper Tank Filter can be reached by removing the
Dirt Container, reaching underneath the Upper Tank and
turning the rim of the Filter Frame to unlock. Pull straight
down to remove. Brush the dirt off the Louvers and
Upper Tank Filter.
The foam Upper Tank Filter may be removed and hand
washed in cold water with mild detergent. Rinse well
then air dry thoroughly before replacing.
The Upper Tank and Louvers may also be wiped clean
with a damp cloth.
NOTE: For easier access, the entire Upper Tank
may be removed by turning the knob on the
back of the cleaner to unlock and pulling the
entire tank straight out.
Use only BISSELL Replacement Filters in your BISSELL Lift-Off.
Pre-Motor Filter 203-1073
HEPA Media Post-Motor Filter #3091
Unplug the cleaner from electrical outlet.
The Pre-Motor Filter protects the motor from dirt particles.
It is located in the slide out tray underneath the Dirt
Container. If the Filter becomes dirty, pull out the tray, lift
out the Filter and clean. This Filter may be hand washed in
cold water with mild detergent. Rinse well and air dry
thoroughly before replacing.
The HEPA Media Post-Motor Filter assists in the filtration
process to return clean air to the room. It is located
behind the door on the back of the cleaner. If the Filter
becomes dirty, open the door, remove the Filter and
replace. The HEPA Media Filter is not washable.
Cleaning The Pre-Motor and Post-Motor Filters
3.
1.
2.
WARNING:
Do not operate cleaner
with damp or wet
Filters or without all
Filters in place.
Pre-Motor Filter
Hepa Media
Post-Motor Filter
1.
2.
Cleaning The Upper Tank & Filter
3.
4.
Upper
Tank
Knob
IMPORTANT:
To maximize your cleaning
performance and extend the
life of your vacuum, it is
very important that you
check and clean your
Filters frequently.
ug603-5539_3750E_304 6/25/04 2:08 PM Page 10