Filter
Top Products
w w w . b i s s e l l . c o m
9
Operations
Carpet cleaning
1. Plug the deep cleaner into a proper
outlet. Turn the power ON by pressing
the red power switch on the back of the
unit with your foot.
2. With your foot, press the gray handle
release lever located on the back of unit
below water tank.
3. While pressing the spray trigger, make
one slow forward wet pass and another
back. Let the BISSELL 2X advanced
deep cleaning formula and DirtLifter
PowerBrush do the work for you.
Caution: Do not overwet.
4. Release the spray trigger and make one
slow forward and backward pass over
the same area to remove any residual
dirty water and aid in drying.
5. Repeat cleaning passes until solu-
tion being pulled up appears clean.
Continue passes without pressing the
trigger until you can’t see any more
water being suctioned up.
1. Turn power switch OFF. Remove the 2-in-1
water tank from the base using the tank carry
handle. Carry the tank like a bucket to a
utility sink or outside where you will dispose
of the collection water. Remove the top of
the tank by rotating the handle forward to
unlatch lid and lifting lid off tank.
2. Empty collection water from bottom of tank.
3. After each use, remove and rinse the lint
screen located on the tank lid.
4. If nozzle needs to be cleaned, remove by
grasping handle at the top and pulling for-
ward. Clean removable nozzle by rinsing
under running water.
5. When finished, replace nozzle by slightly
raising front of machine to line up slots on
the base with the hooks on nozzle. Attach at
base first and then click nozzle into place.
NOTE: If nozzle is not attached prop-
erly loss of suction will occur.
Empty the 2-in-1 water tank/clean removable nozzle
Handle Release
2.
3.
1.
5.
Lint Screen
Power Switch
4.