Filter
Top Products
w w w . b i s s e l l . c o m
11
Operations
Ready Tools™ continued
9. Clean by pressing the trigger to spray
solution onto the area to be cleaned. Slowly
move the tool back and forth over the soiled
surface. Release the trigger to suction dirty
water. Continue to clean in the area, work-
ing in small sections, until dirt is removed.
Caution: Do Not Overwet.
10. When finished cleaning, remove and rinse
tool(s) in clean, running water.
11. It is recommended that you suction clean
water from a bowl to rinse out the hose.
12. Before wrapping hose onto tool rack, lift end
of hose and stretch out to ensure all water is
cleared from hose.
13. Wrap flex hose around tool rack.
14. Empty 2-in-1 water tank and rinse out,
following instructions on pages 9 through
10.
15. If the ReadyTools dial becomes difficult to
turn, the diverter assembly that holds the
dial may need to be cleaned. To clean,
first remove nozzle and locate screw that
holds the diverter assembly in place. With a
Phillips screwdriver, remove the screw and
set aside.
16. Remove diverter assembly; hold under run-
ning water making sure water flows through
and around the dial. Turn the dial about 10
times clockwise and 10 more times counter
clockwise. This should free up any debris.
17. Wipe diverter assembly with a soft cloth and
replace back on machine. Replace nozzle.
18. Return ReadyTools dial to
FLOOR CLEANING setting.
15.
12.
16.
Screw
Run water through here
11.