Filter
Top Products
8
For maximum performance from your BISSELL
®
ProLite
®
Lightweight Upright vacuum cleaner, it is recommended you
perform these simple maintenance checks.
The Dust Bag should be checked weekly. It should be
replaced when it is near full or when cleaning suction
diminishes. Never reuse a Vacuum Bag.
Unplug vacuum.
Unzip cloth Bag. Remove Collar Retainer by pressing on
the two tabs and then pull the top towards you. Slide Dust
Bag collar up and out of retainer. Dispose of Dust Bag.
Slide collar of new Dust Bag completely into Collar Retainer.
Push Collar Retainer back into position and secure in place.
Tuck the remainder of the Dust Bag completely inside
the cloth Bag. Make sure it lays flat, top to bottom,
without bunching. Zip cloth Dust Bag.
Replacement Bag: BISSELL
®
Style 6 Filtrete™
HEPA Bags (#32052, package of 3).
The ProLite
®
features a wide diameter Dust Tube designed to
optimize cleaning power. For best performance it should be
routinely checked and cleared of excess dust and other debris.
Note: It is recommended the tube be cleaned on
a bare floor, or with some newspaper to cover
the floor, to catch any loose material or dust
removed during cleaning.
Release Bag Tension Spring.
Unplug Connector Plug.
Locate the Tube Release Button at the top of the Powerfoot.
The button is hidden under a rubber collar. The button can
be pressed through the rubber collar to release the tube. Lift
off the tube while pressing on the rubber collar.
Use a wire brush to clean out the inside of the tube and
the top section of the Powerfoot where the tube connects.
1.
2.
3.
4.
WARNING: To
reduce the risk of electric
shock, turn Power Switch
OFF and disconnect
polarized plug from
electrical outlet before
performing maintenance or
troubleshooting checks.
Replacing the Dust Bag
1.
2.
3.
4.
Routine Maintenance
5.
Tip:
Vacuum new car-
pet or vacuuming
fine powders may
clog the Dust Bag.
So check the bag
more often
Cleaning the Dust Tube
Tube
Release
Button
Rubber
Collar
Tube
Release
Button
Clean