Filter
Top Products
16
www.bissell.com 800.237.7691
To replace the filter
1. Remove the dirt cup.
2. Grasp the filter frame and pull it straight up
from the dirt cup. Empty the dirt cup.
3. Replace the filter in the dirt cup pushing
down tightly to ensure gasket is in place.
Place the small tab on the bottom of the cup
into the bottom of the canister cavity. Press
the upper portion of the cup into place until
the lock button snaps into place.
You should check your cleaner's rotating
PowerBrush and drive belt regularly for wear
or damage. You should also clean the brush
and brush ends of string, hair and carpet fibers.
These can wrap around the brush and hamper
its ability to effectively clean your carpet. Also,
remove any debris that has accumulated under
the brush cover.
1. Unplug cleaner from electrical outlet.
2. Place unit upside down with brush roll
facing upwards.
3. Remove the four screws as shown with a
small Phillips head screwdriver.
4. Push clearview window outwards from
underneath. Turn unit right side up to
remove window.
5. Grasp rotating PowerBrush and lift out.
Note the white end caps are removable
and may come apart from the brush roll.
6. Clean strings, hair and other debris from
rotating PowerBrush and motor pulley area.
7. Remove old drive belt and discard. Loop new
drive belt over motor pulley and
rotating PowerBrush. Slide the white end
caps on the sides of the PowerBrush into the
slots on the sides as shown. Check brush to
make sure it turns freely.
8. Reposition the clearview window. Turn the
unit over and gently push window at the two
points shown to snap into place.
9. Replace the four screws and tighten.
Maintenance and care (continued)
9
www.bissell.com 800.237.7691
Check rotating powerbrush and replace drive belt
WARNING:
To reduce the risk of
injury from moving parts
and/ or electrical shock,
turn Power Switch OFF
and disconnect polarized
plug from electrical
outlet before performing
troubleshooting checks.
ug010-0136_3108-8_706.indd 9ug010-0136_3108-8_706.indd 9 7/27/06 4:37:34 PM7/27/06 4:37:34 PM