Filter
Top Products
w w w. b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
Operations
10
Carpet cleaning
1. Plug the deep cleaner into a proper out-
let. Set ReadyTools dial to the "FLOOR
CLEANING" setting. Turn the power on
by pressing the red power switch on
the back of the unit with your foot. Turn
heater switch (located on side of unit)
to the on position. Allow one minute for
the built-in heater to warm up before
cleaning.
NOTE: The PROheat will be fully
warmed and will provide optimal
performance after a minute of con-
tinuous heated cleaning.
2. With your foot, press the gray handle
release lever (located on the back of unit
below water tank) to detent handle.
3. While pressing the spray trigger, make
one slow forward wet pass and another
back. Let the built-in heater, BISSELL 2X
advanced deep cleaning formula, and
DirtLifter PowerBrush do the work for you.
Caution: Do not overwet.
4. Release the spray trigger and make one
slow forward and backward pass over
the same area to remove any residual
dirty water and aid in drying.
5. Repeat cleaning passes until solution
being suctioned up appears clean.
Continue passes without pressing the
trigger until you can’t see any more
water being suctioned up.
Tip: Thorough vacuum-
ing before deep cleaning will
prevent early clogging of the
lint trap.
WARNING:
To reduce the risk of fire and electric
shock due to internal component
damage, use only BISSELL cleaning
fluids intended for use with the deep
cleaner. Non-BISSELL cleaning
solutions may harm the machine and
void the warranty.
Power Switch
Heater
Switch
Handle Release