Filter
Top Products
w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
11
Maintenance and care
Power cord storage
When you have finished using your
Easy Vac, store the power cord on
the cord wrap.
1. Turn off vacuum cleaner and unplug power
cord.
2. Loop power cord around cord wraps
on back of cleaner, making certain
Quick Release cord wrap is pointed up
towards handle.
3. Clip molded plug to power cord to
secure.
Clean and replace rotating floor brush
You should check your cleaner’s rotat-
ing floor brush and drive belt regularly
for wear or damage. You should also
clean the brush and brush ends by
removing string, hair and carpet fibers.
These can wrap around the brush and
hamper its ability to effectively clean
your carpet. Also, remove any debris
that has accumulated under the brush
cover.
1. Turn off vacuum and unplug from electri-
cal outlet.
2. Place vacuum upside down with brush
roll facing upwards.
3. Remove five screws as shown with a
small Phillips screwdriver.
4 Lift off brush cover.
5. Grasp floor brush at both ends and lift
out.
6. Clean strings, hair and other debris
from floor brush, motor shaft, and drive
belt.
7. Check floor brush for worn areas and
replace if needed.
8. Check air passageway for obstructions.
Remove debris from this area.
9. When finished cleaning, reposition floor
brush and drive belt. Then replace the
brush cover and five screws.
WARNING:
To reduce the risk of injury from
moving parts and/or electrical
shock, turn power switch OFF and
disconnect polarized plug from elec-
trical outlet before performing
troubleshooting checks.
9.
8.
5.
4.
3.
Air Passageway
Five Screws