Filter
Top Products
8
Attach Bare Floor Tool to unit.
QuickWash (1970 series) — remove Brush before
attaching Bare Floor Tool.
Fill Clean Water/Solution Tank with BISSELL Hard Floor
Solutions
™
to the formula fill line.
Fill the rest of the Tank with hand hot (NOT BOILING) tap
water to the water fill line. Replace and tighten the black cap.
Place Clean Water/Solution Tank on Lower Body.
Press Spray Trigger and slowly move the machine forward
and back over soiled surface one time.
Caution: Do not overwet.
Repeat the motion without pressing Spray Trigger using the
Bare Floor Tool to squeegee and suction up the dirty water.
Repeat steps 5 and 6 until surface is clean.
Allow about 30 minutes for the floor to dry completely.
Turn Power Switch Off.
Unplug Power Cord from outlet.
Remove and empty Collection Tank.
Release Collection Tank latches [1 each side] by
pulling up from bottom of latch and then out.
Carefully lift Collection Tank from Lower Body.
Carry Collection Tank to a toilet or sink. To empty,
pour out contents using opening at back of Tank.
Rinse Collection Tank thoroughly.
Remove lint and hair from Red Gasket in base of
unit. (Do not remove gasket)
Clean Nozzle Window by lifting latch and removing from
machine. Rinse under running water. When finished
replace Nozzle and secure with latch.
Replace Collection Tank on Lower Body and secure
with latches.
Wrap Power Cord around Quick Release Cord Wrap
™
on
side of QuickWash.
Wipe all surfaces with a soft cloth. Store cleaner upright in
a protected, dry area.
NOTE: You may have cleaning solution remaining in
the Clean Water/Solution Tank. You may store your
QuickWash this way for the next cleaning task, but
never keep soiled solution in the Collection Tank.
1.
2.
1.
a.
3.
2.
CAUTION:
Do not store unit
where freezing may
occur. Damage to
internal components
may result.
CLEAN
AFTER
EACH USE
a.
b.
c.
e.
3.
4.
5.
6.
7.
Bare Floor Cleaning
WARNING:
To reduce the risk
of injury from
moving parts and/or
electrical shock, turn
Power Switch OFF
and disconnect plug
from electrical outlet
before performing
maintenance or
troubleshooting
checks.
Routine Maintenance
When You're Done
a.
b.
c.
d.
e.
4.
Dirty
lift by handle
4.
5.
6.
7.
8.
ug603-5601_1970E_1005.indd 8ug603-5601_1970E_1005.indd 8 10/25/05 2:15:21 PM10/25/05 2:15:21 PM