Open as PDF
Remove the Clean Tank by gently pressing the Quick
Release tabs on the Clean Tank and sliding the tank off
of the unit.
Open the tank by unscrewing and removing the cap.
Add water and formula* to the indicated fill lines on the
*NOTE: Your SpotLifter PowerBrush includes an
8 oz. Trial size formula starter bottle.
Replace the cap before placing the tank back on
To aid in the removal of tough, stubborn stains, pre-treating the
stain may be necessary.
Hold the unit above the area to be cleaned. Using the
Manual Trigger Spray, apply a sufficient amount of water
and solution to the stain.
Wait 3-5 minutes before cleaning.
Plug in the unit.
While holding the SpotLifter PowerBrush above the area
to be cleaned, apply water and formula by depressing
the Manual Trigger Spray, dispensing fluid to the
Turn the power switch to the “ON” position. ( I )
How To Use Your SpotLifter
Filling Your Clean/Solution Tank