Filter
Top Products
Deep Cleaning Upholstery
1.
2.
3.
Check manufacturer’s tag before cleaning. “W” or “WS” on the
tag means you can use your Spot Lifter. If tag is coded with an
“S” (with diagonal strike-through), or says “Dry Clean Only,” do
not proceed.
If manufacturer’s tag is missing or not coded, check with your
furniture dealer.
If possible, check upholstery stuffing. Colored stuffing may
bleed through fabric when wet.
Activate vacuum/pump by pressing Power Switch “ON”.
Press front of Spot Lifter firmly against surface to vacuum spill.
Press trigger to spray cleaning solution.
Press front of Spot Lifter firmly against surface to vacuum
cleaning solution.
Check the Collection Tank and empty the tank if it is full. (see
WHEN YOU’RE DONE, page 9).
If Spot Lifter stops spraying, turn off Power Switch and check
cleaning solution level. Refill if needed. Never run dry.
Turn Power Switch to “OFF” position.
Empty the Collection Tank after each use.
Carry Spot Lifter to sink or drain.
Remove the Collection Tank by pressing the Tank Release
Button at the top of the tank, immediately in front of the
handle. The Tank will pivot out on a “hinge” at the bottom of
the unit. Keep one hand underneath Tank as it releases, then
gently lift to disengage the Tank from the hinge.
Cleaning Spills From Hard Surfaces
1.
2.
3.
4.
6.
5.
When You’re Done
1.
2.
3.
4.