Bissell 1715 Vacuum Cleaner User Manual


 
Charging The Battery
When charging for the first time, allow to charge
uninterrupted for at least 24 hours.
Your Spot Lifter should be in charge mode whenever you
are not using it. When charging, the Spot Lifter and charger
may become warm to the touch. This is normal, and no
cause for concern.
Make certain the Spot Lifter is turned OFF. Switch must be
in “OFF” position to charge.
When completely charged, your Spot Lifter will operate for
up to 5 minutes. When completely discharged, it will take
approximately 12 hours to fully recharge.
If necessary, your Spot Lifter can be charged by connecting
the round end of the Power Cord into the special Power
Port at the back of the unit.
Decreased operating time may indicate that the battery has
built up a charging resistance. To recharge, first completely
exhaust the battery, recharge it, then exhaust it once again
before recharging a second time. This procedure may be
required more than once. If your battery still fails to
recharge, or hold a charge through normal duration
(5 minutes), call:
BISSELL Consumer Services
1-800-237-7691
Monday - Friday 8 am. — 10 pm. ET
Saturday 9 am. — 8 pm.
Remove Solution Tank by grasping the indentations with
thumb and finger firmly, and pulling it straight up.
Open the Tank by unscrewing and removing the cap. Add
BISSELL Little Green formula to the indicated “Formula” line
on Tank.
NOTE: Your Spot Lifter is shipped with starter bottle
of formula.
1.
2.
3.
4.
5.
6.
Tip:
For maximum
battery life,
completely
discharge and
recharge Spot
Lifter every
1-2 months.
How To Use Your Spot Lifter
Filling Your Solution Tank
1.
2.