Filter
Top Products
Filling Your Solution Tank Continued
Fill the Solution Tank with warm tap water to the indicated
“Water” line (8-oz.). Replace the cap before placing the
Tank back into the unit.
Replace the Solution Tank by positioning the rubber fitting
into the hole inside the Spot Lifter body. Press Tank gently
until it fits snugly.
Activate vacuum/spray by pressing Power Switch “ON”.
Pre-treat stained or highly soiled areas: Hold Spot Lifter
above soiled surface, then press trigger to spray cleaning
solution.
Wait 3 - 5 minutes before cleaning.
Activate vacuum/spray by pressing Power Switch “ON”.
Hold Spot Lifter above soiled surface, and press trigger to
spray cleaning solution.
Press front of Spot Lifter firmly against surface and pull
toward you to remove cleaning solution and soil.
Repeat Steps 2 and 3 until no more dirt or cleaning solution
can be removed. Do not overwet.
For stubborn soil, use brush to gently scrub soiled area
while continuing to spray cleaning solution. To remove
brush from unit, gently pull on brush tab and lift out.
Check the Collection Tank and empty the tank if it is full.
(See WHEN YOU’RE DONE, page 8).
If Spot Lifter stops spraying, turn off Power Switch and
check cleaning solution level. Refill if needed. Never
run dry.
3.
4.
Pre-treating
1.
2.
3.
Tip:
Fast attention
to a spill on
upholstery
can prevent
permanent
staining.
Deep Cleaning Carpet
1.
2.
3.
4.
5.
6.
7.
Tip:
Use the brush
after you’ve
applied cleaning
solution and
removed any
surface soil.
Using the brush
before this step
can push soil
more deeply
into carpet.