Filter
Top Products
Cleaning the dirt container
Additional steps can be taken to clean the dirt
container as necessary.
1. Ensure the dirt container has been emptied.
2. Remove the lower portion by pressing the
front latch on the upper portion as shown.
3. Clean the screen with a cloth or soft brush
to remove dust or debris.
4. If desired, the lower dirt container may be
washed in warm water. Make sure it is
completely dry before reassembling. Do not
put in dishwasher.
5. To reassemble, hold the carry handle and
place the upper portion into the lower
portion, lining up the front and back latches.
Push down until both latches click into place.
Make sure the dirt container is securely
assembled before replacing it on machine.
Cleaning the pre-motor filter
The pre-motor filter should be checked monthly
and washed as needed to maintain performance.
More or less frequent cleaning may be required
based on individual vacuuming habits and types
of debris picked up .
1. The filter is located in the door labeled
"Filter" behind the dirt container. Push the
tab at the top and swing the door down to
access.
2. Remove foam filter and hold under running
water to wash. Mild detergent may also be
used if desired. Wring excess water from
filter. Air dry thoroughly before replacing.
WARNING:
Do not operate the cleaner with a
damp or wet filter or without all
the filters in place.
10
w ww.b is se ll .c om 8 00 .2 37 .7 69 1
Maintenance and care
WARNING:
To reduce the risk of
electric shock, turn power
switch OFF and disconnect
polarized plug from electri-
cal outlet before perform-
ing maintenance or
troubleshooting checks.
2
3
5