Filter
Top Products
6
Special Features of Your BISSELL ProHeat
™
ClearView
®
The BISSELL SmartClean
®
System
The ProHeat ClearView is a home cleaning system that
automatically mixes hot tap water with the BISSELL
advanced cleaning formula and heats the solution as
it is applied to the carpet. The combination of heated
cleaning solution, powered brush and suction provide a
safe & effective method of cleaning.
Temperature control automatically heats the cleaning
solution as it is being applied to the carpet (*) to safely
optimize cleaning effectiveness.
The Power Switch controls power to the machine; both
switches must be ON for SmartTemp to work.
The SmartTemp Switch is found on the back of the handle
next to the Power Switch. You may choose not to use the
SmartTemp feature if you are cleaning delicate wool or
oriental rugs.
*SmartTemp heats the cleaning solution for carpet
and bare floor application only. It does not heat
solution sprayed through the accessory tools.
The SmartTemp Ready Light indicates when the heater
is ON. The heater should be turned on two minutes before
cleaning, to become fully warmed up and ready to clean.
The Smart Temp Ready Light is found on the front of the
handle where itis easy to see while you clean
SmartTemp increases the water temperature 25° and will
not allow it to exceed 180°.
Provides custom control for each cleaning job.
Lift the SmartMix concentrate bottle up and out of the
machine base.
Turn the bottle over so that the valve cap is in an upward
position. Unscrew the valve cap and fill the bottle to the
mark with BISSELL Deep Cleaning Formula.
Replace the valve cap turning until snug.
SmartTemp
®
1.
2.
3.
4.
SmartMix
bottle
SmartMix
®
1.
2.
3.
O
N
O
F
F
Power Switch
SmartTemp
Switch
ON
OFF
SmartTemp Ready Light